Instructions
  1. Remove access cover from door latch trim piece.
  2. Remove screw behind door panel using Phillips screwdriver.
  3. Remove trim piece surrounding window and lock controls using plastic trim stick.
  4. Disconnect electrical connectors.
  5. Remove connectors on arm rest using plastic trim stick and Phillips screwdriver.

.

Subsequently, one may also ask, how do you open the door panel on a Toyota Camry?

Lift Off Door Panel Lift the bottom of the door panel a few inches away from the door frame and locate the power connector for the "step" or "courtesy" light. Press the release button on the power plug and slide it straight out of the socket. Lift the door panel up and off the metal door frame.

Also, how long does it take to replace a car door? Example: damage to one door will take about 4-5 days to repair, but damage to two doors will take about 6-7 days. If the whole side of a car needs to be repaired and repainted, 2 weeks is a safe bet.

Subsequently, question is, how do you remove the door panel on a 2002 Toyota Camry?

Toyota Camry 2002-2006: How to Remove Door Panel

  1. Step 1 – Prepare to remove door panel.
  2. Step 2 – Remove four of the five screws holding door panel in place.
  3. Step 3 – Remove door pull.
  4. Step 4 – Remove screw inside door.
  5. Step 5 – Loosen door panel.
  6. Step 6 – Remove plastic cover near corner.
  7. Step 7 – Further loosen door panel.
  8. Step 8 – Disconnect wires and remove door panel.

What size speakers are in a 2008 Toyota Camry?

Best Answer. It should have 6x9"'s in the rear. If it was equipped with navigation or the JBL system then it will also have them in the front doors.

Related Question Answers

How do you change the exterior door handle on a Toyota Corolla?

How to Replace Exterior Door Handle 93-97 Toyota Corolla
  1. step 1: Remove the door panel (0:27) Remove the Phillips screw in the inside door handle.
  2. step 2: Remove the outside door handle (2:30) Unbolt the four 10 mm bolts and the one nut to remove the bracket in the door.
  3. step 3: Install the new door handle (4:51)
  4. step 4: Put the door panel back on (7:25)